Manual for Tire Pressure Monitoring Systems, TPMS
6/22
2
Take off the tires and bleed the air. Then take off the air
valve of the tire from the wheel.
(NOTE: You must change
the valve to TPMS valve)
. This part of the process will
normally require the service of a tire fitting service or
mechanic.
3
Recognize the number on each sensor (D)
with position of
tire on the vehicle. (VERY IMPORTANT)
a. RF
– 1
= Right Front, No. 1
b. RR
– 2 = Right Rear, No. 2
c. LR
– 3
= Left Rear, No. 3
d. LF
– 4
= Left Front, No. 4
4
Set up the new TPMS special valve (E) in the wheel.
Use wrench to fix the valve, and then tighten nut to
40~45kgf-cm (4~4.5Nm).
5
Clean inside the tire to prevent the tire from damaging the
transmitter sensor.
6
Inflate the tires
.
Balance the tire
a. Balance tires using a balance machine
b. A lead tire weight may need to be added for balancing.
c.
Balance until the tire balance shows balance as “
OK
”
The Steps above will require the assistance of a tire fitting
service or a mechanic. It is important that the wheels are
balanced after the fitting of the TPMS sensors in order to
ensure the safe operation of the tire when refitted to the
vehicle.
。
7
Set up the other three tires in the same manner.
8
Turn the ignition key of the vehicle until the power is
activated on the cigar lighter, this may be first or second
position depending on the car manufacturer. The in-car
display will be activated.
The function button of the display unit can be switched to
pressure or
temperature depending on the customer’s
need.
