Illustration Legend:
1 - Clip Nut
2 - Rear Rail
2.
Push the back rail against the rack vertical rail.
3.
Secure the back rail to the rack vertical rail with a screw. Use a 10-32 screw for a
rack with square holes (the screw mates with a clip nut).
4.
Repeat for the rail on the other side of the module.
Secure the Expansion Module to the Rack Front
The Expansion Module secures to the rack front with two screws.
1.
Insert a screw in the lower left side of the module and thread it a few turns. Use a
10-32 screw for a rack with square holes (the screw mates with a clip nut).
2.
Insert a screw in the lower right side of the module and thread it a few turns.
3.
Fully tighten both screws.
4.
Install another Expansion Module, if applicable (start with
).
Replace the Cartridge Magazines
Replace the magazines after all modules are installed in the rack.
1.
Verify the magazines are empty. Do not put cartridges in the magazine slots.
2.
Note that left and right magazines are unique. Orient the magazine with the
cartridge slots facing toward the center of the module.
3.
Lift the magazine and engage it the track in the magazine slot.
4.
Push the magazine fully into the slot.
5.
Repeat as necessary until each Expansion Module has two magazines.
Label the Modules
Add stickers at the rear of each module to help with identification.
1.
Locate the scribe lines in the upper left corner of the Expansion Module (as viewed
from the back of the rack).
2.
Obtain the module label sheet from the accessory kit.
3.
Peel the proper label from the label sheet. The sheet has labels for Module 2
through Module 15.
4.
Orient the label properly, align the label with the scribe lines, and adhere the label
to the chassis.
Chapter 2
Install the Expansion Module
2-23
