To Apply Power
The following figure shows how to connect the dual-port adapter with a copper cable.
2.
Insert the other end of the copper cable into an empty SFP+ cage on the FCoE
switch.
After the copper cable is connected to the adapter, you can power on the system.
Note -
Link Aggregation Control Protocol (LACP) cannot be used on the same port as FCoE or
iSCSI.
To Apply Power
1.
Verify that the Converged Network Adapter is securely installed in the system.
2.
Verify that the correct data cable is attached.
3.
Refer to your system installation or service manual to determine how to power
on the system.
4.
Observe the light-emitting diode (LED) status for the power-on self test (POST)
results as shown in this section.
Chapter 2 • Hardware Installation and Removal
25
Содержание 7105381
Страница 2: ......