8
Operation:
The main switch is located at the top of the shredder. It can be set in three positions:
●
ON/AUTO - after choosing this option the equipement is ready for use. It starts automatically when
the paper is inserted and stops automatically when no further paper is in the slot
●
OFF - this option is recommended during a long standstill
●
REV - When setting the main switch to REV position this will helps to remove paper if it gets stuck
inside the cutting blades. It can also be used for cleaning the shredding mechanism
When the waste bin is full the machine does not stop working remember to remove/empty shreds from the bin often.
Notice!
Pay attention during the fitting of the cutting head on the bin. Improper fitting will cause a malfanction
in operation of the shredder or damage sensor or the sensor tab on the bin
Performance:
Shreds up to 7 sheets of 70 g/m2 paper at one time. Maximum paper format tha can be shredded is
A4. Insert paper into the center of the feed slot.
There is a special slot of (60 mm) in the middle of the cutting head. It is designed for shredding plas-
tic cards, and can shred only one plastic card at s time.
The next special slot of (122 mm) for CDs/DVDs also on the top of the cutting head. The amchine can
destroy only one CD/DVD at time. CDs/DVDs are destroyed by strip dotting.
Cleaning:
●
Before cleaning the shredder ensure that the main power switch is switch off, then unplug the
equipement from the mains socket.
●
When the shredded paper bin gets overfilled, it may cause problems and paper will go inside the
mechanism feed and there is a risk of fire. Pull the bin out, remove shreds and re-install the bin
under the shredder
●
To avoide problems please clean the shred bin regularly before it overfills
●
Cleaning the housing. Wipe the cover of the shredder with a gentle home detergent or a damp piece
of cloth
●
Do not put the equipement tinto water
●
Do not wipe the unit with petroleum, thinners, alcohol or solvents - they can cause permament
damage to the housing and the plastic
Maintenance:
●
To prevent reduction of efficiently, increased sound levels and to prolong the lifespan of the
equipement, it is necessery to the oil cutting blades regularly
●
After filling the waste bin several times, the blades should be oiled with a special oil (provided by
OPUS)
●
Put a little oil on a few pieces of paper and shred them so that the oil will spread on the whole
cutting mechanism
User’s guide VS 711 CD
