User’s guide VS 2000 CA User’s guide VS 2000 CA
Possible malfunctions:
When the machine does not function or functions incorrectly, please check
the following:
•
If the machine is plugged in?
•
If the main switch is on “ON” position?
•
If there is no paper stuck inside the shredding mechanism?
•
If the cutting head is installed correctly? (the safety switch located
under the cutting head works only if the cutting head and waste bin
are correctly installed)
In case of further malfunctions contact authorized service team.
Cleaning of the volume for shreds:
Cleaning the volume for shreds is necessary, when the shreds can be seen
in the bin window. To empty the bin:
•
Pull the shred bin out of the shredder.
•
Empty the bin.
•
Push the bin into the shredder.
Some paper scraps may remain inside the shredding mechanism after
emptying the shred bin, it can cause increasing sound level temporarily.
Maintenance:
To prevent reduction of efficiency and increase of sound level as well as to
prolong machine lifespan, it is necessary to oil cutting shafts regularly. After
filling the waste bin for several times, the blades should be greased with
special oil (provided by OPUS). Put the oil on few pieces of paper and
shred them so that the oil was spread on the whole cutting mechanism.
5
Recommendations:
•
The machine is designed to shred paper, plastic cards and
CD/DVDs.
•
Clean up the waste bin frequently
•
The shredder can be operated only with paper bin included.
•
To ensure long and faultless utilisation of the machine do not shred
more than 20 sheets of 70g/m². Do not shred computer printout,
PVC foil, coated paper or cardboard – it can cause damage of
cutting mechanism.
•
Do not shred more than one CD at one time. Before shredding put
the CD into the envelope or between two sheets of paper.
•
NOTE! Desk-side shredders are not designed for continuous
operation.
•
It is recommended to make 30 minutes break after every 15
minutes of shredding. The shredder is protected against
overheating. When the max temperature of engine is exceeded the
machine turns off automatically.
•
Do not set REV mode, if it is not necessary
NOTE! Not complying with the recommendations above can result
with warranty void.
