OPUS TB 250 • User guide
GB
7
3
OPERATING
Preparation of the equipment
1. Place the equipment on steady and level surface.
2. Check there is nothing in the heating slot.
3. Plug the equipment into the mains socket, 220-240 Volts AC, 50-60 Hz.
4. Pull out the cooling rack (4) from the side of the housing.
5. Switch the power on (2) which is on the top of the equipment.
6. When the red light is on it is heating up, when the green light come on it is ready
to use.
Preparing covers and documents:
• Choose proper cover size by using the table below.
• Put the pages into the cover so that all pages touch the glue strip, inside the spine
ensuring the pages are even.
Cover size
Number of sheets
Mini
1 - 15
3 mm
16 - 30
4 mm
31 - 40
6 mm
41 - 60
8 mm
61 - 80
10 mm
81 - 100
12 mm
101 - 120
14 mm
121 - 150
18 mm
151 - 180
20 mm
181 - 200
22 mm
201 - 220
Binding
• When the green light comes on you are ready to start binding.
• Put the pages together with the cover into the binding slot with the spine facing
down.
• When you hear a bleep signal this tell you that the binding process has finished.
• Remove the bound documents from the slot and put them into the cooling rack on
the side.
• If you leave bound documents in the binding slot it will repeat the binding cycle
again, and you will hear a double bleep signal inform you it is finished.
• You should leave the bound document for at least 10 minutes after binding for the
glue to set completely.