Healht & Safety precautions:
●
Before operating the equipment please read the Health & Safety precautions, manufacturer
recommendations and the operation manual.
●
The operation manual should be easily available at any time for the operator.
●
The equipment should be installed on sturdy and level surface near a 220 - 240 V, 50 Hz socket.
●
The equipment should be protected against dust and moisture
●
The equipment must not be placed near the heating or ventilation units.
●
The equipment must not be used in vicinity of inflammable liquids or gases
●
The power supply cable should be protected against damage and must not be used to pull
the equipment or to remove the plug from the socket.
●
The equipment must be kept away and out of from reach of children.
●
Danger! The equipment contains eclectically driven rollers. Ensure long hair, loose jewellery,
ties and other loose pieces of clothing are keep away they can be get entangled in the rollers.
●
The equipment must not be used for any other purposes than those indicated in the instruction
manual to do so will invalidate the Guarantee/Warranty.
●
It is necessary to check and supervise if the equipment is operated correctly.
●
In case of any malfunction, you must contact the dealer or service team.
●
The equipment must not be located outside and should be operated in a room temperature
higher than + 8 °C.
●
Before removing any covers from the equipment, remove the power plug from a mains socket.
●
Using inappropriate lubricants can cause a fire hazard.
●
Any repairs must be carried out by authorised staff only.
●
The equipment must be operated according to general Health & Safety rules.
●
Do not leave the equipment in operation without an operator.
●
After use turn the equipment off by the switch on unit, next remove the plug from a socket.
Recommendations and requirements:
●
Use only recommended supplies and accessories.
●
Do not put into the laminator documents thicker than 0.7 mm. The laminated material should
always have similar properties.
●
Remove the mains power plug from the socket before moving the equipment or during longer
none operation.
●
If the equipment is switched on and is not operated for more than one hour, it could get
overheated. To avoid bad quality lamination put 1 or 2 sheet of A3 paper through in order to cool
the rollers down,
●
Always insert the laminating pouch with the close end into the laminator first. Putting the open
end first can cause bubbling and the film getting stuck on the rollers inside the laminator.
●
In the case of a document that has got stuck inside the laminator, use reverse function REV switch
to reverse the document out, if this fails call or take your equipment to the Dealer or Service team.
●
Laminating with one layer laminating foil requires the use of a carrier. ASK YOUR DEALER.
●
A carrier is a folder that has a shiny surface, which stops the foil sticking to the rollers.
●
Tailor cut pouch can make the rollers sticky and dirty and they can wind round the rollers use
a carrier.
●
Remove all metal elements (staples & paper clips, etc.) before laminating the document.
●
NOTE! The equipment contains heater elements, be aware high temperatures!
●
NOTE! Not compliance with the rules and recommendations above can void the
Guarantee/Warranty.
User’s guide popLAM A3
7
