3.
Safety Instructions
We do not assume liability for resulting damages to property or personal
injury if the product has been abused in any way or damaged by
improper use or failure to observe these operating instructions. The
warranty will then expire!
3.1 Product Safety
The product must not be exposed to substantial mechanical strain
or strong vibrations.
The product must be protected against electromagnetic fields,
static electrical fields, extreme temperatures, direct sunlight and
moisture
The manufacturer’s instruction for the respective batteries must be
observed, before they are charged.
The product should not be connected immediately after it has been
brought from an area of cold temperature to an area of warm
temperature. Condensed water might destroy the product. Wait
until the product adapts to the new ambient temperature before
use.
Sufficient ventilation is essential when operating the charger. Never
cover the ventilating slots of the charger.
3.2 Battery Safety
Correct polarity must be observed while inserting the batteries.
Non-rechargeable batteries, rechargeable alkaline batteries (RAM),
lead acid batteries and lithium batteries must not be charged with
this product. There is danger of explosion!
Batteries should be removed from the device if it is not used for a
long period of time to avoid damage through leaking. Leaking or
damaged batteries might cause acid burns when in contact with
skin, therefore use suitable protective gloves to handle corrupted
batteries.
Batteries must be kept out of reach of children. Do not leave the
battery lying around, as there is risk, that children or pets swallow
it.
When charging current more than 1.0A is selected for charging,
charger should not be left unattended in house. Though charger
provides overheat protection, but some defects is not controllable
by charger itself. There should have people around during
charging.
Batteries must not be dismantled, short-circuited or thrown into fire.
Never recharge non-rechargeable batteries. There is a risk of explosion!
3.2 Miscellaneous
Repair works must only be carried out by a specialist/specialist
workshop.
If you have queries about handling the device, which are not
answered in this operating instruction, please check with the
distributor for further help.
4.
Operation
Once a rechargeable battery is inserted, battery voltage (for example,
“1.12v”) will be displayed. If
MODE
or
CURRENT
button is not pressed,
BT-C100 charger will start the working mode in 10seconds. If
Current
button is pressed to select different working current, then 3 seconds after
key operation, charger will start the working mode. For those batteries
with impedance higher than 250mR, charger can only accept charging
current not larger than 1.0A due to safety consideration reason.
Working mode programming
Li-ion battery type programming
USB Output Programming
