Opus 500 system, Руководство пользователя

Страница: 12 / 14

12
IMPORTANT!
This MCU500 should only be programmed using
LRC500 V2.5 (or higher).
Earlier versions of LRC500 are not compatible and
must not be used.
Installing IR codes for your new
source
First teach the LRC500 learning remote control the
IR commands for your new source. See the LRC500
manual for further details.
Next use the cloning operation to download the new
codes to the MCU500. To perform this connect the
LRC500 to the MCU via the mini-jack to mini-DIN
cloning cable. The IR indicator on the MCU will
illuminate showing cloning is active.
Press the TRANSMIT button on the LRC500 for three
seconds. You will hear a beep and the transmit mode
screen will appear.
Press each flashing number in order until they have
disappeared. The device screen displays the ‘Tx’
icon.
(If the LRC500 is version 1 you will need to press the
LRC500’s button to start the transmitting
operation.)
The LRC500 ‘Tx’ icon and the MCU’s IR indicator will
flash.
When the data is transfered the ‘Tx’ icon will stop
flashing.
Exit the transmit mode by pressing the LEARN
button.
Current pre-set
from bank FM stereo
Digital tuner wave
band display
Current source display
Signal level
Note: Full 10 bars are required
for optimal quality reception
Stereo sound
MCU500 LCD display
LRC500 programming