CamRecord CR-S3500
Ref. 1900-SU-02-C
Page 14
Start of operation (Network / IP Address configuration)
1. Please connect the camera power supply to the power connector of
the CR camera and then connect the power supply to the 110-
240 Volt power source. The camera will operate after switch on the
power switch on the camera backside (I..0) to position (I).
Make sure, that your PC has a Gigabit Ethernet (GigE) interface. To
operate the CamRecord-Sprinter cameras, please set both camera
and PC network adapter on the same subnetwork:
Please note, that the IP Address may either be changed in the Personal
Computer (Network card) or in the camera or both.
To set the IP Address in the Personal Computer please ask your System
Administrator.
To set the IP Address of the camera please use an USB2 Stick formatted
to
FAT32
and use the Optronis tool IPConfiguration:
1)
Star
t IPConfiguration tool “IPConfiguration.exe” to create a text
file IP.CFG
2)
Copy IP.CFG to the USB2 Stick
3)
Power off the camera and plug the USB2 Stick into the CR-
S3500 camera
4)
Power on the camera and wait, until boot time has finished (see
led states detailed later in the document).
5)
USB2 Stick can be removed once the boot is finished.
Alternatively
1)
Create a text file on the USB2 Stick named: IP.CFG
2)
Open the text file and write 2 lines. First Line is the IP of the
camera (e.g. 192.168.100.254), second line is the Subnet mask
(e.g. 255.255.255.0)
3)
Save the file, plug it to the camera, power on the camera and
wait until the camera has booted.
4)
After boot, the camera has accepted the new IP address.
Alternatively
1)
Plug an empty USB2 Stick to the camera
