Frequency Search
Should the receiver not respond to the controller after installing the driver
see “Installing the
Wireless USB Receiver” on page 7
, reset the transmission and reception frequency between
controller and wireless USB receiver using the following procedure.
1
Plug the wireless USB receiver into an available USB port.
2
Press the
Connect Key
on the wireless USB receiver. The
Status LED
starts flashing.
If the frequency search is not complete within
1 minute
, the LED will still stop flashing.
3
Remove the battery on the LR4.
4
Press the
Power button
while re-install the battery.
While inserting the battery, the LCD screen lights up for
1 second
and then go out.
5
Release the Power button after the LCD screen goes out.
The Status LED will go out at the same time.
6
The wireless transmission is reset. Now the LR4 is ready to use.
