32
E
nglish
XGA
SVGA
Appendices
Changing the Lamp
The projector will detect the lamp life itself. It will show you
a warning message Lamp may fail soon ! Replacement
Suggested ! When you see this message, change the lamp as
soon as possible.
Make sure the projector has been cooled down for at least 30
minutes before changing the lamp.
Warning :
Lamp
compartment is hot!
Allow it to cool down
before changing lamp!
Lamp Changing Procedure:
1.
Turn off the power to the projector by pressing the Power/
Standby button.
2.
Allow the projector to cool down at least 30 minutes.
3.
Turn off the main power switch.
4
. Disconnect the power cord.
5.
Use screwdriver to remove the screw from the cover.
6.
Remove the cover.
7.
Remove the 3 screws from the lamp module.
8.
Pull out the lamp module.
To replace the lamp module, reverse the previous steps.
Warning :
To
reduce the risk of
personal injury, do not
drop the lamp module
or touch the lamp bulb.
The bulb may shatter
and cause injury if it is
dropped.
1
2
3
4
v
The model shown is
the SVGA.
