11
A12.1095
3-9 Using the filter
（
Fig.10
）
In the normal using state , the frosted filter is at
the push-in state.For dark field observation or
phase contrast observation, press the lever to cut
the frosted filter out of the light path and increase
the brightness of view.
3-10 Using the extensional function
board
（
Fig.11
）
As shown in Fig11, the nosepiece reserves a slot
to hold the extensional function board. The
ordinary bright and dark field board has been inset
the slot before the microscope leaving factory. If
using other extensional function board,
only need
to loosen the screw
①
, pull out the standard bright
and dark field board, then inset the extensional
function board into the slot and tighten the screw
②
.
3-11 Computer control signal interface
and photo function key (Fig. 12
、
13)
Connect the external digital camera
supported by the company to the computer,
and connect the computer control signal
output interface (as shown in FIG. 13) on
the back of the microscope to the computer.
Meanwhile, the computer runs
scopeimage10.0 software. After capturing
the real-time image of the camera, press the
photographing function key in Figure 12,
The picture captured by the current camera
will be recorded immediately (see the
software operation manual for the operation
application on the computer).
①
②
Fig.11
Photo button
USB
interface
Fig.13
Frosted filter switch lever
Fig.10
Fig.12
