REMOVING A SNAP PID MODULE
16
SNAP PID Module User’s Guide
Removing a SNAP PID Module
To remove a SNAP PID module, use
the SNAP module tool that came with
the module.
1.
Holding the SNAP module tool
as shown in the illustration at
right, insert it into the notch at
the base of the module.
NOTE: If you are facing the rack
with the brain on the left side,
the notch is on the back of the
module.
2.
Squeeze the module tool
against the module to open the
release latch, and pull straight
up on the module to remove it.
Troubleshooting
If you encounter problems using the SNAP-PID-V, please review the information below for
solutions to common problems. If this information does not solve your problem, contact Opto 22
Product Support. Contact information is found on
of this guide.
Ethernet Brain Communications
If you are having trouble establishing an Ethernet network connection with the SNAP Ethernet
brain, refer to the Troubleshooting section in Opto 22 form # 1112, the
SNAP Ethernet Brain
User’s Guide.
If Ethernet communications problems continue after you have tried the solutions in
that guide, contact Opto 22 Product Support for assistance.
SNAP PID Module Access
Check the following items if there are problems accessing the PID module on the SNAP rack:
•
Check that the correct kernel version is installed on the SNAP Ethernet brain. See
Brain Compatibility” on page 3
for instructions on how to check the Ethernet brain’s kernel
version.
