OPTO 22 LCSX-PLUS, Руководство по установке

Страница: 27 / 30

SNAP-LCSX AND LCSX-PLUS Installation Guide
23
23
1: Specifications and TroubleshootingChapter 1
Specifications and
Troubleshooting
SPECIFICATIONS
Item Specification
CPU 32-bit Motorola 68EC020 processor
CPU clock frequency 16.67 MHz
Memory
RAM
Flash ROM
1 MB with battery backup
256 KB
RAM/clock battery 3.6-volt lithium, non-rechargeable, user replaceable, p/n G4BATT32
I/O Opto 22 remote I/O using RS-485
Communication
COM 0:
jumper selectable as RS-232 or RS-485, 2-wire or 4-wire. Modem
control signals are present for RS-232 (RTS, CTS, DTR, DCD, and R).
Pull-up, pull-down, and termination are jumper selectable for RS-485 opera-
tion, allowing multidrop operation.
COM 1:
dedicated Opto 22 remote I/O port (2-wire RS-485 with interrupt capa-
bility)
COM 2 and COM 3 (LCSX-PLUS only):
jumper selectable RS-232 or RS-485.
RS-232 signals include TX, RX, RTS, and CTS. RS-485 is either 2-wire or
4-wire, with selectable termination and biasing.
Note:
All ports use low-noise slew-rate-limited drivers and are transient pro-
tected to 400 W.
Real-time clock Clock/calendar, Epson 64613 with battery backup
Power requirements 5 VDC ± 5% at 500 mA (maximum)
Typical operating temperature 0
°
C to 70
°
C
Storage temperature -40 ° C to 85 ° C
Humidity 5% to 95% relative humidity, non-condensing
Software
FactoryFloor (OptoControl, OptoDisplay, OptoServer, and OptoConnect) and
Classic software (Cyrano, Mistic MMI, and MDS)
System monitor Processor and power watchdog timers