Figure 5: Top to bottom: USB cable, power plug and audio jack
NOTES:
In case a hard reset of the unit is necessary, unplug the power supply and wait until the power led (led closest to the fan) is fully
extinguished before reconnecting the power supply (A large buffer capacitor on the cradle board needs about 10 seconds to
discharge).
4
DRIVER INSTALLATION
Following drivers are available for Win XP, Win 2K and Win XP x64 edition:
•
Device: GlobeTrotter Module 3G+
•
Multifunction Adapter: GlobeTrotter Module 3G+ Flip-Flop Bus
•
Port: GlobeTrotter Module 3G+ Diagnostics Port
•
Port: GlobeTrotter Module 3G+ Application Port
•
Network: GlobeTrotter Module 3G+ Network Card
•
Modem: GlobeTrotter Module 3G+ Modem
•
Smart Card: GlobeTrotter Module 3G+ Smart Card Interface (Optional)
For full functionality of your module, you need to make sure all drivers are installed correctly.
4.1
Installation procedure:
(1) If you have not already done so, install and connect the cradle as described in chapter 3. The unit is
connected correctly only if the “Found New Hardware” balloon and subsequent “Welcome to the
Found New Hardware” Wizard appears.
Figure 6: Found New Hardware
OPTION NV, Gaston Geenslaan 14, 3001 Leuven - Belgium
Tel +32 16 317 411 Fax +32 16 207 164 http://www.option.com
Option Confidential
