OPERATING INSTRUCTIONS:
SETTING UP
•
Carefully remove your fan from the box (please save the carton for off-season
storage).
•
Make sure the unit is in the OFF position before plugging the unit into the outlet.
OPERATING
1)
Place fan on a firm level surface.
2)
Plug the power cord into any standard 120V AC, 60HZ outlet. Please make sure
the Selector (Speed Control) is in the OFF position.
A loose fit between the AC
outlet and plug may cause over heating of the plug. Have a qualified
electrician to replace the old outlet if the power cord feels extremely hot.
3)
Tilt and adjust the fan head to the desired angle or airflow.
4)
3 Speed Press-button Switches:
The switch is located on back of the unit. Select
the desired fan speed setting by pressing the switch button. To stop the fan, press
the button 0.
CLEANING
During Season Care:
•
Before cleaning, be sure to turn off and unplug the unit.
•
Keep the fan clean. Carefully wipe the unit with a soft, damp cloth. Please be very
cautious near the motor.
•
DO NOT immerse the fan in water and never allow water to drip into the Motor
Housing.
•
Never use gasoline, benzene or thinner. This will damage the surface of the unit.
•
After cleaning, be sure to completely dry the unit with a cloth or towel.
After Season Care:
•
Your fan can be stored in the off-season.
•
Before putting the fan in storage, clean it thoroughly, cover it with a vinyl bag, and
store it in a cool and dry place. We recommend using the original (or appropriately
sized) box.
ASSEMBLY INSTRUCTIONS
(refer to the picture)
a)
Dismantle the 4 screws from the inner ring of the round base.
b)
Line the pole with the screws holes in round base from where the screws were
dismantled. Fix the pole tightly with screws.
c)
Dismantle the screws from the top of pole.
d)
Dismantle the screws from the support tube which is under the U shaped tube of
the head.
e)
Through the support tube, insert the head into the inner pole.
f)
Firmly fix the head and the pole together with the screws.
g)
Assembly is now completed.
FAN DIRECTION ADJUSTMENT
1)
Do not attempt to make any adjustments to the direction of the grille and fan
assembly until the fan has been turned off and unplugged from the socket.
2)
To adjust the direction of the fan, hold the grille and gently tilt the fan until the
desired position is reached.
3)
Plug the fan back into the socket and turn the fan on.
MAINTENANCE INSTRUCTIONS:
A loose fit between the AC outlet and plug may cause over heating of the plug. If the
plug over heats, it might cut off the fuse inside the power cord plug.
If your fuse access cover is located on the side of the plug:
•
Grasp plug and remove from the receptacle or other outlet device. Do not yank the
cord to unplug.
•
Select a suitable tool such as a small flat screwdriver or travel scissors.
•
To open the fuse cover. Slide open fuse access cover on top of attachment plug toward
blades. (see fig.1)
•
Carefully remove the fuse by prying it out. (see fig.2)
•
Risk of fire can result by using wrong fuse rating. Replace fuse only with 5.0 Amp,
125 Volt rating.
•
To close the fuse access cover. Slide to close access cover on top of attachment plug.
(see fig.3)
Fig.1 Fig.2 Fig.3
