AVR-A-OPT-02
Rev. 01 de 31/05/2016
OPTIMUS TECHNOLOGY
Página 22 de 35
5.4
-
C
ONEXÃO DO
G
ERADOR COM
B
OBINA
A
UXILIAR
T
ENSÃO
320
A
600V
CA
/
G
ENERATOR
C
ONNECTION
WITH
A
UXILIARY
C
OIL
V
OLTAGE
320
TO
600V
AC
/
C
ONEXIÓN DEL
G
ENERADOR CON
B
OBINA
A
UXILIAR
V
OLTAJE
320
HASTA
600V
CA
1
Item não fornecido pela
OPTIMUS;
2
Se não houver potenciômetro
conectado, jumpear pinos no
jumper 6 e 7 (curto-circuitar);
3
Disjuntor de 10A/250Vca
(curva C) para ligar e desligar o
regulador
(dispositivo
de
interrupção).
* Tensões de linha do gerador,
conforme
a
classe
de
realimentação e o nível de
tensão de alimentação do
regulador,
conforme
as
características técnicas.
Atenção
1-Antes de conectar o regulador
ao gerador, verifique no manual
de instalação a tensão nominal
de referência;
2-Utilizando bobina auxiliar, o
conector E3/4, referência do cir-
cuito do regulador, deve ser
obrigatoriamente o ponto co-
mum entre bobina e gerador;
1
Item
not
supplied
by
OPTIMUS;
2
If
there
is
not
any
potentiometer connected, jump
pins in the jumper 6 and 7 (short
circuit);
3
Circuit breaker of 10A/250Vac
(curve C) to turn on and off the
regulator
(disconnecting
device).
* Line voltage of the generator,
as per sensing class and
regulator supply voltage level,
according to the technical
specifications.
Attention
1-Check the rated reference
voltage in the installation man-
ual before connecting the regu-
lator to the generator;
2-While using the auxiliary coil,
the connector E3/4 which is the
reference circuit of the regula-
tor, it is mandatory to be the
common point between the coil
and the generator;
1
Ítem no suministrado por
OPTIMUS;
2
Si no existe potenciómetro
conectado, haga jumper de los
pines en el jumper 6 y 7
(cortocircuitar);
3
Disyuntor de 10A/250Vca
(Curva C) para encender y
apagar el regulador (dispositivo
de interrupción).
* Voltajes de línea del
generador, conforme la clase de
realimentación y el nivel de
voltaje de alimentación del
regulador, de acuerdo con las
especificaciones.
Atención
1-Antes de conectar el regula-
dor al generador, verifique en el
manual de instalación el voltaje
nominal de referencia.
2-Utilizando la bobina auxiliar,
el conector E3/4, referencia del
circuito del regulador, debe ser
obligatoriamente el punto co-
mún entre la bobina y el gene-
rador;