Optimum OK-1690, Руководство по эксплуатации, Страница: 14 / 56

14
Gently tap the filter against the side of a rubbish bin to remove
excess dirt (Fig. 6/4).
The central filter can be rinsed In warm water (max 40°C).
Allow to air dry completely before replacing (Fig.6/5).
Return the central filter to the dirt container. Replace the dirt
container as directed.
Pre-motor Filter
Lift up the vacuum cleaner lid as directed. Pull out the pre-
motor filter as shown (Fig. 6/6).
The pre-motor filter can be rinsed in warm water (max 40°C).
Allow to air dry for 24 hours before replacing.
Return the pre-motor filter to the vacuum cleaner and close the
vacuum cleaner lid.
Post-motor Filter
NOTE: This is located on the back of the vacuum cleaner.
Release the post-motor cover by pressing down on the two
catches at the top of the cover (Fig. 6/7).
Remove the filter by pulling away from the casing (Fig. 6/8).
The post-motor filter can be rinsed In warm water (max 40°C).
Allow to air dry for at least 24 hours before replacing.
Return the post-motor filter to the casing and re-fit to the back
of the vacuum cleaner.
7. Storage
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet and rewind the power cord as
directed before storing.
NOTE: Always store the vacuum cleaner base down.
8. Troubleshooting
WARNING: To reduce the risk of personal injury,
unplug the vacuum cleaner before performing maintenance
or troubleshooting checks.
PROBLEM: Vacuum cleaner won’t run
Cause: Not properly plugged Into electrical outlet.
Solution: Plug In securely.
Cause: No electricity in the electrical outlet.
Solution: Check fuse or breaker.
Cause: On/off switch not turned on.
Solution: Push on/off switch to ‘on’.
Cause: Motor thermostat has tripped.
Solution: Switch off and unplug the vacuum cleaner.
Leave for one (1) hour before switching the vacuum cleaner
back.on.
Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
PROBLEM: Cleaner won’t pick up/loss of suction.
Cause: Dirt container not installed properly.
Solution: Review dirt container replacement.
Cause: Dirt container full or blocked.
Solution: Empty dirt container.
Cause: Clogged filters.
Solution: Remove, clean and replace filters.
PROBLEM: Accessories won’t pick up. .
Cause: Accessories are not attached correctly.
Solution: Refer to section 5.
Cause: TurboTool is clogged.
Solution: Refer to section 7.
Cause: Hose is not installed correctly.
Solution: Refer to section 7.
Fig. 6/4
Fig. 6/5
Fig. 6/6
Fig. 6/7
Fig. 6/8