Optimum ES-1217, Руководство по эксплуатации

Страница: 13 / 15

13
15. Drip tray
16. Boiler outlet
17. Steam/hot water nozzle
18. Measuring spoon with tamper
19. Filter for 2 cups dose
Features
1. Powerful pump
The appliance is equipped with a powerful 15 bar pump
capable of producing excellent espresso and cappuccino.
2. Aluminum boiler
The appliance is equipped with a thick aluminum boiler that
heats fast and has excellent steam, hot water capacity.
3. Removable drip tray
The drip tray is removable for easy cleaning.
4. Detachable water tank
The 1.5L transparent water tank with hinged lid is detachable
for easy cleaning and refilling.
5. Safety system
The appliance is equipped with pressure relief valve, thermal
fuse and dual thermostat to prevent from overheating and
overpressure.
6. Froth enhancing function
The appliance is equipped with a froth-aid device, enjoy
abundant milk froth for cappuccino within minutes.
7. Keep warm function
The top warming tray is available to keep the cups warm.
Before using for the first time
1. Remove all packaging.
2. Wind excess cable around the storage slot on the bottom of
the machine.
3. Wash the parts, please refer to “Cleaning”.
4. Flush the machine through with clean water in the
following steps:
a) Make sure the all buttons are in the off position and
that the steam/hot water knob is closed by turning
clockwise.
b) Lift out the tank, draw up the lid and fill with cold water
up to the MAX level marked. Alternatively draw up the
lid and fill the tank whilst in position on the espresso
machine.
We recommend using filtered water as it produces better
coffee and reduces limescale, never use fizzy water.
c) Refit the tank, make sure that it is correctly located and
apply light pressure if necessary to ensure the valve at
the bottom of the tank connects with the water inlet of
the machine.
It is normal for water to remain in the compartment
under the tank, this can be done using a sponge.
d) Swing out the steam/hot water nozzle then attach the
filter holder to the machine by positioning it under
the boiler outlet and turning to the right, place a bowl
underneath.
e) Plug in the mains supply, Press down the On/Off button
then the power light will glow.
f) Immediately press down the coffee/hot water button and
wait until water drip from the filter holder. This means
the boiler has been filled with water.
Note: You have to operate this step as soon as possible,
otherwise the boiler will be dry-boiled.
Important: You can not brew espresso if you have not flushed
the machine at first, the flushing cycle causes the boiler to fill
with water. If you have not used the machine for a few days,
you have to flush it with fresh water before you use it again.
Preheating the espresso machine
To ensure your espresso coffee is brewed at the right
temperature it is essential that the coffee appliance is preheated.
1. Check that the steam/hot water knob is firmly closed
(turn clockwise) and that there is water in the tank.
2. Put a jug under the steam/hot water nozzle.
3. Fit the filter into the filter holder (without coffee) and attach
to the machine by positioning it under the boiler outlet and
turning to the right, ensure is it firmly located.
4. Position two cups under the filter holder, if you use the same
cup that the coffee will be served in it will be preheated.
Alternatively the cups can be preheated on the cups
warming tray.
5. Press the On/Off button and wait until the ready light glows.
6. Press down the coffee/hot water button and wait until cup of
water runs into the bowl.
7. Turn the steam/hot water knob anti-clockwise and allow
a little amount of water to run into the jug.
8. Turn the steam/hot water knob clockwise and turn the all
buttons to off setting.
9. Remove the filter holder and proceed to make coffee.
To make espresso using ground coffee
1. Preheat the appliance as above ‘Preheating the espresso
machine’.
2. Check that there is water in the tank.
3. Add the coffee using the measuring spoon provided one full
spoon per cup, level the surface then lightly press with the
tamper of the measuring spoon, wipe off any coffee around
the rim.
When buying ground coffee sure it is suitable for espresso
machines.
Never press the coffee too firmly as the coffee will come out
slowly and the cream will be of a dank colour, however, if it
is pressed too lightly ,the coffee will come out too fast and
the cream will be a light colour.
4. Attach the filter holder into the boiler outlet, turn it to the
right to lock into position.