Optimum 3403020, Руководство по эксплуатации

Страница: 10 / 102

Safety
Version 1.0.2 - 2020-07-20 10 Translation of original instruction
TM3310 | TM3310D EN
T
M
3310_
GB_1
.f
m
1.5 Potential dangers that can be caused by the lathe
The lathe has been tested for operational safety. The construction and type are state of the art.
Nevertheless, there is a residual risk as the lathe operates with

high revolutions,

with rotating parts,

electrical voltage and currents,
We have used design and safety engineering to minimize the health risk to personnel resulting
from these hazards.
If the lathe is used and maintained by personnel who are not duly qualified, there may be a risk
resulting from incorrect or unsuitable maintenance of the lathe.

Obligations of the operating
company on page 10
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must

be duly qualified,

and strictly follow these operating instructions.
In the event of improper use

there may be a risk to the persons,

there is a risk of damage to the lathe and other property,

the correct function of the lathe may be affected.
Always disconnect the lathe, when cleaning or maintenance work is being carried out.
WARNING!
The lathe may only be used with the safety devices activated. Disconnect the lathe
immediately whenever you detect a failure in the safety devices or when they are not
mounted!
1.6 Qualification
1.6.1 Obligations of the operating company
The operator must instruct the personnel at least once a year regarding

all safety standards that apply to the lathe.

the operation,

generally accepted engineering standards.
The operator must also

check the personnel‘s knowledge level,

document the training/instruction,

have attendance at the training/instruction confirmed by signature and

check whether personnel is working in a manner that shows awareness of safety and risks.

Define and document the machine inspection deadlines in accordance with section 3 of the
Factory Safety Order and perform an operational risk analysis in accordance with section 6
of the Safety at Work Act.
1.6.2 User's obligations
The operator must

have read and understood the operating manual,

be familiar with all safety devices and regulations,

be able to operate the lathe.