Optimum 3403020, Руководство по эксплуатации

Страница: 14 / 102

Safety
Version 1.0.2 - 2020-07-20 14 Translation of original instruction
TM3310 | TM3310D EN
T
M
3310_
GB_1
.f
m

Wear safety goggles.

Do not remove the turning chips by hand. Use a chip hook and / or a hand brush to remove
turning chips.

Clamp the turning tool at the correct height and with the least possible overhang.

Turn off the lathe before measuring the workpiece.

The instructions described in these operating instructions must be strictly observed during
assembly, operation, maintenance and repair.

Do not work on the lathe if your concentration is reduced, for example, because you are
taking medication.

Stay at the lathe until all movements have come to a complete standstill.

Use the prescribed personnel protective equipment. Make sure to wear a well-fitting work
suit and, if necessary, a hairnet.
1.12.1 Disconnecting and securing the lathe
Turn off the main switch of the lathe before starting any maintenance or repair work.
Use a padlock to prevent the switch from being turned on without authorization and keep the
key in a safe place.
All machine parts as well as all dangerous voltages are switched off.
Excepted are only the positions which are marked with the adjoining pictogram. These positions
may be live, even if the main switch is switched off.
Attach a warning sign to the lathe.
WARNING!
Live parts and moves of machine parts can injure you or others dangerously!
Take extreme care if you do not switch off
the lathe by turning off the main switch due to required works (e.g. functional control).
1.12.2 Using lifting equipment
WARNING!
The use of unstable lifting and load suspension equipment that might break under load
can cause severe injuries or even death.
Check to ensure that the lifting and load-suspension equipment are of sufficient load-
bearing capability and are in perfect condition. Fasten the loads carefully. Never walk
under suspended loads!
1.12.3 Mechanical maintenance work
Remove or install protection safety devices before starting or after completing any main-
tenance work; this include:

covers,

safety instructions and warning signs,

grounding cables.
If you remove protection or safety devices, refit them immediately after completing the work.
Check that they are working properly!
1.13 Electronics
Have the machine and/or the electric equipment checked regularly. Immediately eliminate all
defects such as loose connections, defective wires, etc.
A second person must be present during work on live components to disconnect the power in
the event of an emergency. If there is a fault in the power supply, switch off the lathe immedi-
ately!