Optimum 3403020, Руководство по эксплуатации

Страница: 11 / 102

Safety
Version 1.0.2 - 2020-07-20 11 Translation of original instruction
TM3310 | TM3310D EN
T
M
3310_
GB_1
.f
m
1.6.3 Additional requirements regarding the qualification
Additional requirements apply for work on electrical components or equipment:

They must only be performed by a qualified electrician or person working under the instruc-
tions and supervision of a qualified electrician.
Before starting work on electrical parts or operating agents, the following actions must be taken
in the order given:

disconnect all poles,

secure against restarting,

check that there is no voltage.
1.7 Operator positions
The operator position is in front of the lathe.
1.8 Safety measures during operation
CAUTION!
Danger due to inhaling dust and mist that are hazardous to health.
Dependent on the material which need to be processed and the used auxiliaries dusts
and mist may be caused which might impair you health.
Make sure that the generated health hazardous dusts and mist are safely sucked off at
the point of origin and is dissipated or filtered from the working area. To do so, use a
suitable extraction unit.
CAUTION!
Risk of fire and explosion by using flammable materials or cooling lubricants.
Extra precautionary measures must be taken before machining flammable materials (e.g.
aluminium, magnesium) or using combustible agents (e.g. spirit) to avert a health
hazard.
CAUTION!
Risk of becoming entangled or lacerations when using hand tools.
The machine is not designed for the use of hand tools (e.g. emery cloth or files). It is
forbidden to use any hand tools on this machine.
Extra precautionary measures must be taken before machining flammable materials (e.g.
aluminium, magnesium) or using combustible agents (e.g. spirit) to avert a health
hazard.
1.9 Safety devices
Use the lathe only with properly functioning safety devices.
Stop the lathe immediately if there is a failure on the safety device or if it is not functioning for
any reason.
It is your responsibility!
If a safety device has been deactivated or is defective, the lathe can only be used again if you

the cause of the fault has been eliminated,

you have verified that there is no danger to personnel or objects.
WARNING!
If you bypass, remove or override a safety device in any other way, you are endangering
yourself and other persons working on the lathe. The possible consequences are:

injuries due to components or workpieces flying off at high speed,

contact with rotating parts and

fatal electrocution,