Version 1.1.2 - 2022-02-24
64
Translation of original instruction
S 131 GH
EN
S131
GH_GB
_3.
fm
Place the collecting tray on the machine
substructure. Make sure that the holes in the
collecting tray and the machine substructure are
aligned.
Place the metal band saw on the machine
substructure.
Attach a load slings to the vise and the rear part of
the metal band saw. Make sure that the load
attachment point is balanced.
Use an adequate conveyor equipment, for instance
a crane.
Make sure that the load attachment does not cause
damage to components or paint.
Img.3-3:
Assembly 3
Fasten the metal band saw with the hexagon socket
screws on the machine substructure. To do so, use
the fixing material included in the delivery.
CAUTION!
Danger of crushing and tilting. The installation of
the metal band saw must be performed by at least 2
persons.
Img.3-4:
Assembly 4
3.4.3
Transport lock
Remove the transportation lock on the front side of
the saw frame.
Img.3-5:
Disassembly of the transportation lock
3.4.4
Material stop and protective plate
Mount the material stop.
Fix the material stop on the vice using the threaded
pin.
Push the saw stop onto the stop rod.
Lock the saw stop using the limit stop fixture.
Mount the protective plate onto the vice.
Img.3-6:
Assembly of material stop and protective
plate
