Optimal Audio provide a set of hardware options for rack mounting SmartAmp in
several ways.
Rack Kit A (see Appendix A) is suitable for rack mounting both full and half-rack-
sized units and enables coupling of half-rack-sized units to fit two SmartAmp 10
or 20 into a single rack space.
Rack Kit B (see Appendix B) is for providing rear support to units when mounted
in mobile racks and other more demanding situations
SmartAmp Wall Mount (See Appendix C) is used for mounting any of the
SmartAmp range against flat surfaces
SmartAmp 30 is shipped with rack mount ‘ears’ attached as illustrated above and
is primarily intended to be installed in an equipment rack. The installation and
equipment rack should be configured to provide appropriate ventilation airflow
space around the sides and rear of the amplifier. Ventilation airflow space of at
least 25 mm (1 in) should be maintained along at least one side of the amplifier
at all times. Ventilation apertures are also located on the rear panel of the
amplifier and must not be obstructed. It is important to retain at least 80 mm (3.1
in) free space for airflow behind the amplifier rear panel.
Installation & Rack Mounting
SmartAmp 30 showing rack ears and with the rear support attached
11/20
SmartAmp
Amplifiers with DSP
Amplifiers
USER GUIDE
© 2021. Optimal Audio Group Ltd. (v1.0)
Introduction
Overview
Start using
Power up
Rear panel
Inputs
Outputs
>
<
Dip switches
GPIO
Installation
Maintenance
Tech specs
Appendix A
Appendix B
Appendix C
Safety info
