6
OPERATING INSTRUCTIONS
Preparation:
• Turn machine on
• Allow to warm up for five minutes
To weigh:
• Add weight to the scale, the display will show result
• Use the unit key to change between units
To tare:
• The Tare function is used when you only wish to see the current change in
weight, not the entire amount of weight that is on the scale
• Example: Put a container you wish to use on the pan, then press the TARE key
and the display will show the tare symbol
and reset back to 0
• Add your sample to the container to weigh without the weight of the container
• To exit Tare mode simply press TARE
Note: If you remove your container the scale will show the minus weight of the
container
To count:
• The counting function is used to count a high volume of identical parts. You can
do this by setting a sample and then either adding to the sample or taking away
from the sample to count the number of objects on the scale
• This function can calculate the quantity with total weight divided by signal weight
• Press and hold MENU until the screen reads
--Mode-
• Press CAL to enter and the screen will read
-COUNT-
• Press CAL again and the screen will read
SAMPLE
• Press CAL again to display the sample quantity ex.
0000020
pcs
• Press PRINT to cycle through sample quantities and select
• To set the quantity manually: Press UNIT to move the cursor to the left and the
PRINT key to increase the number value
• Press CAL to select
• The display will show the results
• Upper left displays the quantity: 20pcs
• Upper right displays the unit weight: 0.11g
• Main window displays the total weight: 2.200g
• Remove samples from pan, the display will show
0.00
g
• Place an unknown amount of pieces on the pan and the scale will count
(Example: put 100pcs, total weight 11g)
• To exit counting mode pres and hold TARE key
Note: to exit the present counting state and restart a new counting state, Press CAL
to enter a new sample
