EDFA-MP-MSA
User’s Manual
Page 1 of 9
Optilab, LLC
600 E. Camelback Road, Phoenix, AZ 85012
Phone: (602) 343-1496, Fax: (602) 343-1489, Email: [email protected]
1. General Information
1.1 Introduction
This manual contains information on the installation and operation of the EDFA-MP-
MSA modular erbium doped fiber amplifier (EDFA) unit.
1.2 Product Overview
The Optilab
EDFA-MP-MSA
EDFA Module is an ideal building block for
photonic subsystems and OEM system integration. Using an FBG stabilized,
uncooled pump LD, this low power (LP) version of the EDFA module is
designed for minimal electrical power consumption and thermal loading. Pump
laser protection and alarms are equipped to ensure the reliability and safety of
the device. The module requires only a single 5VDC power supply for operation,
with total current draws as low as 260mA in saturation output mode.
1.3 Features
•
Low power consumption of less than 1.5W
•
High stability
•
Low noise
•
Low polarization dependence
•
Modular Design for OEM Integration
1.4 User Safety
1. The EDFA-MP-MSA unit emits high intensity invisible light from the optical
output receptacle. Avoid direct exposure to skin and eyes.
2. The module case is fully certified for EMS protection. The user should
never open the module case; any attempt will void the warranty and may
result in electric shock and EMS attack to equipment in the vicinity.
3. The user should avoid using any solvent or vaporizing chemical to clean the
exterior. It may result in damage to the surface and internal circuits.
