Programming
a Prefix or Suffix Option
After scanning the
START/END
code on page 10
or 11, select the desired symbology to add a prefix
or suffix by scanning the appropriate code under
the Symbologies Suffix Selection table (Note: All
prefixes or suffixes previously assigned to this
symbology will be erased).
Each prefix or suffix character is assigned a two
digit (ASCII) code identifier. Look up the code for
the character(s) desired as either a prefix or suffix
in the ASCII-HEX Character Chart located on pages
17-19. Using the alphanumeric bar codes on
pages 15 and 16, scan the two digit identifier for
the first character of the prefix/suffix. Repeat
scanning additional two digit identifiers for up to 4
characters maximum. The Back Space and Clear
All bar codes can used to correct any errors in
scanning. Back Space clears the previous alpha-
numeric code or the previous character. Clear All
erases all previously scanned characters.
Repeat the above (starting with selecting a new
symbology) for any other symbologies or end the
procedure by scanning the
START/END
code.
Page 7
