Troubleshooting
The display displays only black screen.
•
Check that all AC and DC plugs and jacks used by external power
supplies (both Opticis and others) are firmly connected.
•
Ensure that power LED lit ON.
•
Ensure that the Uplink and Downlink modules connected correctly to
the PC and display, respectively.
•
Check if the PC and display are powered on and properly booted.
•
Reset the M5-1002 using Reset button on Uplink and Downlink
modules.
•
Ensure your graphic card is set at no higher than SXGA
(1,280x1,024) at 60Hz refresh ratio.
•
Re-boot up the system after reconnecting the SC optical fiber.
Screen is distorted or displays noises.
•
Check if the graphic resolution is properly set. Go to the display
properties and tap the settings. Ensure that the resolution sets less
than SXGA (1,280x1,024) at 60Hz refresh ratio.
•
Reset the M5-1002 using Reset button on Uplink and Downlink
modules.
•
Reset the system.
•
Power down, disconnect and reconnect the SC optical fiber or DC
power adaptors, and power up.
Maintenance
No special maintenance is required for this product. Ensure that this product
is stored or used in a benign environment free from liquid or dirt
contamination.
There are no user serviceable parts. Refer all service and repair issues to
Opticis or its authorized distributor.
Technical Support and Service
For commercial or general product support, contact your reseller. For
technical service, contact Opticis by email
or visit its
website at
www.opticis.com
.
1-5 Troubleshooting, Maintenance, Technical Support
Product Specifications
M5-1002 Optical DVI + Audio Extender
Compliance with DVI standard:
supports DVI 1.0 of DDWG, using
fiber-optic communication links and DDC2B.
Extension limit:
2km (6,560feet) for SXGA (1,280x1,024) 24bit
color at 60Hz refresh rate in ultimate operation. Distances up to
10km (32,800feet) using Virtual DDC-EEPROM.
Audio:
3.5mm Stereo jack.
RS232C:
supports D-sub 9 Pin connectors for RS232C.
Fiber-optic Connection:
The transmitter and receiver boxes of M5-
1001 have duplex SC receptacles connected to two 8/125
µ
m or
Single Mode glass fibers cables.
Mechanical specifications of Uplink and Downlink boxes
Dimensions:
180mm / 120mm / 30mm (W/H/D)
Weight:
835.0
±
3.0 gram
for each of Uplink and Downlink
modules.
Environmental Specifications
Operating temperature: 0°C to 50°C
Storage temperature: - 20°C to 70°C
AC/DC Power Adapter
Power Input:
Universal AC 85-264V, 50/60Hz, AC power cord with
power jack.
Power Output:
+12 V, 3.0 A SMPS DC-power Adapter
Cord DC Jack & length:
Core is 12 V and outer cylinder is GND.
Length is 18.5 cm
AC Cord length: 1.8m
Certification
:
PSE, UL, cUL, FCC, CE, TUV-GS
1-6 Product Specifications
