- 10 -
8.
Connection (Installation)
Important: Please follow the installation procedure below. Improper or no operation may be
resulted, if the start-up sequence is not followed correctly.
Step 1
Carefully unpack the contents of the shipping group.
Step 2
Turn on the PC, display, and network switch.
Step 3
Turn on the PC for Video Wall control SW and connect network cable (CAT5e or CAT6) to
network switch.
Step 4
Connect HDMI IN port in IPVDS-500E (TX) to the PC by supplied HDMI cable.
Step 5 (Optional)
Connect mini USB port in IPVDS-500-E (TX) to USB port in PC with supplied USB cable.
You may skip Step 4 if you don’t need local and remote control with Keyboard and mouse.
Step 6 (Optional)
Connect Local Display port in IPVDS-500-E (TX) to local HDMI display by HDMI cable.
Step 7
Connect LAN port (RJ-45) in IPVDS-50-0E (TX) to LAN port in Network switch with LAN cable.
Step 8
Connect HDMI OUT port in IPVDS-500-D (RX) to remote HDMI display by supplied HDMI cable.
Then, attach keyboard and mouse for remote control.
Important: You have to connect IPVDS-500-D (RX) to each video wall display according to
order of serial numbers of IPVDS-500-Ds (RXs). Refer to OSD Numbers for video wall displays
Step 9
Connect LAN port (RJ-45) in IPVDS-500-D (RX) to LAN port in Network switch with LAN cable.
Step 10
Plug the +5V power adaptors to both IPVDS-500-E (TX) and IPVDS-500-D (RX).
Note1: If you change an input source to another source, you have to reset the power of all TXs
and RXs by re-plugging of the +5V power adaptor.
