Installation
Important: Please keep the installation procedure below. Improper or no
operation may result if the start-up sequence is not correctly followed.
Step 1
Carefully unpack the contents in the shipping group.
Step 2
Power on the HDMI source and display. Power on both transmitter and
receiver by using either USB power by USB to DC plug cable or 5V DC power
adapter.
Step 3
Then, the LED (Green color) will begin to blink three (3) times per
second regularly on both sides.
Figure 2
– Position of the LED
Step 4
Connect four (4) LC optical fibers between the transmitter and the receiver
and each fiber channel shall be connected as A to A and B to B carefully.
Ensure the connectors are fully engaged and then, the top LED (Green color)
will begin to blink regularly.
Fig Figure 3
– Fiber numbering & Caution on both fiber ports
1-3 Installation
Note 1:
The maximum extension length by multi-mode fiber is 300 meters.
Fig Figure 4
– Connection of optical fiber
Step 5
Connect the transmitter to the HDMI source by supplied HDMI copper cable.
Step 6
Connect the receiver to the HDMI display over HDMI copper cable.
Note 2:
Be recommended NOT to use any other intermediate cables or
adapters between source and transmitter and display and receiver except the
supplied cable to avoid undesirable performance degradation.
Note 3:
If the connectors are fully engaged, the bottom LED (Green color) will
turn on.
Step 7
If the system does not work properly, go to the page 1-5 trouble shooting.
1-4 Installation
Position of the LED
