opticis HDCX-100-TR Скачать руководство пользователя страница 3

Installation 

Important: Please keep the installation procedure below. Improper or no 
operation may result if the start-up sequence is not correctly followed. 

Step 1 

Carefully unpack the contents in the shipping group. 

Step 2 

Connect one (1) CAT5e or CAT6 cable between the transmitter and the 
receiver. 

Step 3 

Connect the transmitter to the HDMI receptacle of PC or other HDMI video 
source equipment by HDMI cable 
If necessary, connect the RS-232 cable between 3pin terminal of HDCX-100 
and D-sub 9pin of PC and the USB cable between receptacle USB of  HDCX-
100 and receptacle USB of PC. 

Step 4 

Connect the Connect the receiver to the HDMI display over HDMI copper 
cable. 
If necessary, connect the RS-232 cable and USB cable  to RS-232 device 
and USB device. 
 

Step 5 

Power on the HDMI source and display. Power on both transmitter and 
receiver by using supplied power supply.

 

Note 1. Indicator information of HDCX-100 

HDCX-100 LED Indicator 

Enable 

Disable 

Blue LED(POWER) 

ON 

OFF 

Green LED(LINK) 

ON 

OFF 

Yellow LED(HDCP) 

ON 

OFF 

 
 
1-3 Installation

 

 
Note 2:

 Be recommended NOT to use any other intermediate cables or 

adapters between source and transmitter and display and receiver except the 
supplied cable to avoid undesirable performance degradation. 

Note  3:

  Be  recommended  to  use  the  SFTP  cable  between  transmitter  and 

receiver to prevent a signal interference problem. 

In case of UTP cable, please use the straight type cable.  

(Be  recommended  to  NOT  to  use  the  rolled  cable  type  to  avoid  undesirable 
performance degradation.) 
 

Step 7 

If the system does not work properly, go to the page 1-5 trouble shooting. 
 

 

▪  

Bracket installation guide 

(Mounting Bracket is optional) 

 
The following image provides instruction for installing the transmitter and/or 
receiver unit(s) in the bracket of HDCX-100-TR 
 
Step 1. Put on the HDCX-100 unit on bottom bracket. 
Step 2. Line up holes between top bracket and bottom bracket. 
Step 3. Install countersink screws.  
Step 4. Ensure the unit is installed securely 
 
 
 
 
 
 
 
 
 
 
 
 

 

Figure 2 

– Bracket installation of HDCX-100-TR 

 

 

1-4 Installation

 

 

 

Отзывы: