Optical Systems Design OSD730, Руководство оператора

Страница: 9 / 20

OPTICAL SYSTEMS DESIGN
DOC ID: 10102908
OSD730 OPERATOR MANUAL
Page 9
2. INSTALLATION AND OPERATION
2.1 INTRODUCTION
This section outlines the methods required to install and operate the OSD730 successfully. This information
should be studied carefully if damage to the equipment or poor results are to be avoided.
This equipment has been fully tested prior to dispatch and is ready for immediate operation. However, it is
advisable to check for external transportation damage prior to operation. If damage is detectable, return the unit
and the packaging to the supplier.
2.2 INSTALLATION
2.2.1
WARNING AND PRECAUTION
▲
ELECTROMAGNETIC COMPATIBILITY
WARNING : This is a Class A product. In a domestic environment this product may cause radio interference
in which case the user may be required to take adequate measures.
▲
OPTICAL OUTPUT OPERATION
WARNING : Laser Safety: Class 1 Laser Product per IEC/EN 60825-1:20011 standard.
Class 1
The OSD730 is a Class 1 laser product.
PRECAUTIONS
▲
All service personnel should be provided training as to the hazards of direct viewing of laser radiation
and of the precautionary measures during servicing of equipment
▲
Areas where laser products are installed should be restricted in access to trained service personnel only
and appropriate warning signs posted in the work area.
▲
All laser apertures should be covered by protective covers when not connected to optical fibers. Never
leave outputs uncovered.
▲
Laser equipment should be positioned above or below eye level where possible. Apertures should be
positioned away from personnel.
▲
Protective eyewear should be worn in the vicinity of laser equipment.