Note>>
9
Close the cover.
8
Connect the cables and complete setting and alignment.
(refer to page 8, 9)
Note>>
Run the cables so that they are not pinched between the
chassis and back box.
5
6
Caution
Hook on the upper part of
the chassis.
Push the lower part of
the cover until it clicks
into position.
1
2
Pass the cables through the wiring hole of the chassis and
mount the chassis to the back box.
Fasten the cover lock screw.
3
• For more information on wiring, see “WIRING” on page 7.
• Put the cables in order
not to be caught
between the main unit
and cover.
• Push the middle part of
the cover and hide this
orange label
completely when in
operation.
• Do not contact with the optical unit when mounting
the cover. Otherwise malfunction may occur due to
the shift of the optical axis, resulting in the need of
readjustment.
Banding band
Wiring notch
Pull
7
Fix the main unit on the chassis.
Insert the lower part, and
then push the upper part
onto the chassis.
1
Turn the optical unit 90 degrees
and tighten the screws (both sides).
2
fasten
fasten
fasten
Caution
• Avoid cables from being caught between chassis.
• When the waterproof packing is detached, be sure to
attach it on the back of the chassis before mounting.
Not doing so may compromise IP rate of this
product.
Force into
a groove
Caution
• Tighten the screws
completely by torque
of 1.0 - 1.5 N·m.
Not doing so may
cause malfunction of
wall tamper.
Orange label
A cover must hide this orange label completely when in operation.
PORTUGUÊS
DEUTSCH
IT
ALIANO
ESP
AÑOL
FRANÇAIS
ENGLISH
EN-4
