Tamper
Signalling LEDs
P.I.R.
Sensor
Anti-Remove
2.
RFX sensor board disposition
PROG Key
1.
Mounting and wiring the RFX sensor
6. TMP N.C.
5. TMP N.C.
4. ALM N.C
3. ALM N.C.
2. GND (0V)
1. + 12 Vcc
a) Place the sensor at the center of the HIGH side of the area to be PROTECTED
(between Window and roller shutter or immediately outside the roller shutter)
b) Fix the MAGNET in the wall at 1 cm. to Sx or Dx from the center of the long side of the
sensor by making an hole by the drill .
c) Put anti-remove jumper onto ON if the magnet is plugged in , otherwise in OFF position
(no Anti-remove function setted)
d) Fix the SENSOR using the 2 dowells supplied of 5mm. by the 2 holes on the sensor sides
e) Connect Tamper and Alarm OUTPUT (N.C.) contacts and the power supply (+ 12V / GND)
f) Close the sensor cover and lock it with the screw in the center and put the screw cover
g) Make some passages trought the gateway to verify its operation
ON OFF
Red
Yellow
