Opt Lasers PLH3D-6W-XF, Руководство пользователя

Страница: 26 / 27

Support and Manuals
26 / 27
Additional Features
Applicable to PLH3D-CNC adapters sold after 20-July-2020:
1.
Enable Option Check at Power-on.
After turning the key switch ON, the current Enable Option setting will be displayed with indication
LEDs for a second. Please refer to the table with Enable Option LED combinations, which can be found
in the preceding subsection, namely Enable Options. After a second, the display of the currently
selected Enable Option LED combination will disappear. The LEDs will then show the status of the
device and the adapter will be ready for use.
For more details about the "Enable Options", please visit the foregoing subsection.
2.
Laser Head Type Selection.
In order to best recognize a variety of laser head critical states (disconnecting by the external switch,
disconnecting the cable, short circuit), a general type of the laser head can be set up. The following
settings are possible:
* - In this case, discontinuity of the laser head can only be recognized at sufficient laser power, hence
it depends on how the PLH3D-CNC Aenpuerru conurollrnn rnp uu nre errven.
To check or set up the laser head type option:
1. Turn the key switch off.
2. Press and hold the mode button.
3. Turn the key switch on while holding the button.
4. Wait at least
4 seconds .
5. Release the button.
6. LEDs will show a combination corresponding to the current setting (please refer to the table
above).
7. To step to the next setting press the button.
8. To save the current setting wait 5 seconds with the button released. To quit without saving, turn
the key switch off before 5 seconds elapse.
The chosen setting is kept in non-volatile memory and remains unchanged during power-off.