30
Safety Precautions
●
When liquid other than water is adhered
• If any liquid other than water (seawater, detergent, alcohol, etc.) is
adhered, wash off with water immediately.
• You can wash it under tap water of weak flow (less than 6 litter
per min.) at room temperature (5
℃
- 35
℃
) at a distance of
approximately 10 cm away from a tap or showerhead.
• If the product gets soiled, wash it with hands holding the SIM
card/microSD memory card tray to not open. Do not use a brush
etc.
●
When the product gets wet
• When the product gets wet, drain water and wipe off with dry
clean cloth.
• In cold regions, water droplets on the product may freeze. Using
with droplets frozen may cause a malfunction. Do not leave those
water droplets on the product.
●
Rubber gasket
• The rubber gasket on the SIM card/microSD memory card tray
plays an important role for maintaining waterproof performance.
Do not damage or remove it.
• Be careful not to get the rubber gasket pinched when closing
the SIM card/microSD memory card tray. If you attempt to
forcibly close the tray with the rubber gasket pinched, the rubber
gasket may be damaged and that hinder maintaining waterproof
performance. Even a fine mote (a piece of hair, etc.) between the
contact surfaces may cause water ingress.
• If liquid other than water (alcohol etc.) is adhered, durability
performance may not be able to be maintained.
• Do not insert a sharp pointed object into the gap of the SIM card/
microSD memory card tray. The product may be damaged or
deformed, or the rubber gasket may be damaged and that causes
water ingress.
• You are recommended to replace the parts to maintain water
performance every two years regardless of existence of abnormity.
For replacing parts, contact the number given in the "
取扱説明書 詳
細版
(Instruction Manual)" (Japanese).
●
Heat resistance property
• Do not soak into hot water or splash hot water. Also, do not use
the product in a sauna or apply hot airflow of hair dryer etc. The
product is not heat resistant.
●
Impact tolerance
• The product is not impact resistant. Do not drop the product
or give impact to the product. Also, do not poke the receiver,
speaker, mouthpiece/main microphone, sub-microphone, etc.
with a sharp pointed object. The product may be damaged or
deformed and that causes water ingress.