3
5
Place the geared motor (3) in the hole as shown so that it rests with
the body on the base plate.
Note:
cable connections are on the right in the direction of travel!
7
Glue the two wooden parts (1e) as shown on the upper side in front of
the gear motor. Let the glue dry firmly.
8
Glue the head mounting bracket (2c) onto the geared motor as shown.
1e
9
Glue part (1f) as shown flush with the sloping edge of part (2a). Then
glue the middle part (1g) onto part (1g) with an indentation of approx.
8-10 mm. Glue rudder 2 mirror-inverted to paddle 1.
10
Place the two paddles from both sides on the axles of the gearbox as
shown. Fasten them with one screw (7) each through the 2mm hole.
Note:
screw must meet the flattened side of the drive axle.
7
3
6
Screw the ring notch (8) into the hole provided as shown.
8
1e
2c
2b
2a
1g
1f
2a
7
flattened side
Building Instruction 122.072
Recycling Rowing Boat
