3
E109818#1
35mm
Instructions
12. Put the brass case (9) into the 5mm
hole to use it as mouthpiece.
14. Wrap the bending wire (4) hard
around a round bar or a cardboard
tube..
Note:
The diameter should be 20-25 mm
thereby the polystyrene ball fits well.
15. Use the pliers to bend the legs of the
wire by 180° in the opposite direction)
16. Place a washer (8) on the cylinder
head screw (5) and plugging both
through the hole from bottom to
top
17. Place a washer (8) on the screw and
tighten it with a nut (6) as shown.
18. Screw another nut (6) onto the screw
and place a washer (8) on it
19. Place the bent bracket on the screw
as shown
20. Then place a washer (8) on it.
21. Secure the support with the cap nut
(7).
22. Last place the polystyrene ball.
Done!
23. Colour the game at will
screw
air hole in
the cover
bending template
13. Bend the bending wire according to
the template and cut the overlaying
ends
