3
12
11
7
1
7
8
9
10
ø4
5c
5c
1
3a
8
5c
8
3b
5c
ø4
Fix the handle in the base and mark the drillings with the drill. Then re-
move the handle and drill approx. 5 mm deep holes into the markings
on the base .
Drill through the handle a ø 4mm hole, that is approx. 30 mm inden-
ted. See picture!
Instructions 117.329
Hand Sander - Wood
The length of the base plate depends on the used sandpaper! Glue
the wooden strip (1) on the foam rubber plate (7). After the glue has
dried, cut the protruding pieces with a tinker knife. Tip: weight the
strip!
Glue part (3a) flush and centric on the wooden strip (5c) and fix it with
2 screws (8) as shown. .
Glue part (3b) flush and centric on the wooden strip (5c) and fix it with
2 screws (8) as shown. .
If necessary shorten the
base by 20mm!
Glue a woodcutting (5c) flush to the outer edge of the base (1) as
shown. On the opposite side measure and mark 20mm then glue the
other woodcutting (5c) on the base.
