2
1
2
2
3
3
4
5
3b
3a
ø1,5
5a
5b
5b
5a
5b
5a
5a
5c
5c
6
After drying, grind down the glued handle for approx. 1 mm with
sandpaper.
Instructions 117.329
Hand Sander - Wood
Cut out the template on page 5 and glue it on the plywood (2) by using
adhesive tape. Saw out the handle and clean the saw cuts. The size of
the handle depends on the use of the sanding paper!
Cut out the template on page 5 and glue it on the modelling plywood
(3) by using adhesive tape. Drill both parts (3a + 3b) for 1,5 mm as
shown. Saw out the holder and clean the saw cuts.
Measure and mark four 60 mm long pieces on the wooden strip
(5a+5c). Then cut the strip along the marks and clean the saw cuts. In
addition drill two ø 1,5 mm holes into two strips (5c) as shown.
Mark a notch according to the shown dimensioning on one wooden
strip (5a, 5b, 5c, 5d). Then saw out the notch.
Glue a wooden strip (60mm) flush to the front edge of the wooden
handle as shown. Moreover glue the in step 4 cutted part (5b) inside
to the back of the wooden handle. Use the wooden strips without
drilling holes.
If necessary, use the
dashed template, which
is 20 mm shorter!
