6.1 Designing and making the see-saw
6.1.1 Mark out and drill the holes in the pine strip (2)
Note:
the holes are different sizes!
6.1.2 Mark out the parts for the support as shown (3) and saw into the individual sizes
NOTE: It is best to mark out the parts with dividers, then saw each length, finally place the pieces on top
of each other and drill them in a single action.
6.1.3 Once the parts have been drilled , mark out and cut the joints and the notches for the candle holder
Note:
To make the construction
easier you can simply glue the
parts of the support on top of each
other
instead of cutting the joint
(See diagram below)
5
E104689#1
Ø 2,50
Ø
2
200
90
3
10
2,50
79°
Ø 3
Ø 2,50
Ø 3
17 23
23
300
8
63
8
Version with joint
Glued version
2
3
3
