D
D1:
Dome base
D2:
Camera liner
D3:
Dome cover
D4:
Notches (on both sides)
Installing The Dome Enclosure
1 Remove the dome cover and the camera liner
Gently turn the dome cover counter-clockwise to unlock and pull free of the dome base. Remove the camera
liner by gently pulling it free of the two notches (
D4
) in the camera base (see fig
D
).
2 Use the template to mark-out and prepare the mounting area
4 Mount the dome enclosure
Using one of the mounting schemes discussed overleaf (Methods for mounting the enclosure), fix the dome
enclosure in place.
6 Adjust the camera position
You can adjust the focusing position by rotating and tilting the camera base (see fig
E
).
7 Install the camera liner
Carefully fit the camera liner (
F1
) over the camera base so that it snaps into place as shown in fig
F
and does
not obstruct the camera lens.
8 Replace the dome cover
Replace the dome cover (
F2
) and rotate to close it as shown in fig
F
. Use the supplied T2 screw to secure the
whole enclosure (see fig
G
).
9 Install the Quick Mount Kit (optional) (see fig H)
a. Use the screws to adjust the position of the two locking arms on the Quick Mount Adapter.
b. Thread cables through the Quick Mount Adapter (
H1
) and install it onto the dome enclosure.
c. Attach Camera to Quick Mount Install Adapter using the thread.
5 Connect the connectors
All wires have been connected to the circuit board seated on the
dome base. When the enclosure is mounted securely to a surface,
connect your video out and power in cables to the
G1
and
G2
con-
nectors.
A service jack socket is also provided for temporary video con-
nection when focussing the camera, using an optional Service
jack socket.
Important: Use only a Class 2 certified power supply.
Service jack
socket
E1
E2
F1:
Camera liner
F2:
Dome cover
Push the camera liner
up to the base until it
clicks into place.
F
H
G
G1
G2
T2 screw
F1
F2
H1
D1
D2
D3
D4
Rotate and tilt the camera
base to the required position.
E
G1:
Video output connector
G2:
Power input connector
Cut out the mounting template and mark then drill the mounting holes for the chosen installation method.
3 Open the required knock-out panel
The 200-Series High-Res Dome Camera is designed to maintain the IP and NEMA rating independent of the
chosen installation method. Therefore, all mounting access positions are sealed until they are ready to be
used. Use a sharp knife or side cutter pliers to cut one of the side knock-outs (
C3
) to the size required to allow
cable entry. Be carefull not to hurt yourself or damage the camera when using knives or side cutter pliers.
360º
rotate
83º
tilt
