ooznest C-Beam Machine, Руководство по сборке

Страница: 6 / 40

C-Beam Machine Getting Started 4
1.4 Notes on Assembly
The assembly has been split into 4 sections: Power Supply Assembly, CNC xPro
Assembly, Wiring & Commissioning. To make locating parts quicker, leave the parts in
the boxes they came in when carrying out the build.
It is recommended that you read through the whole manual before beginning the build in
order to get a full picture of the assembly process. Before beginning each step, make
sure you have studied the diagram and have the required parts in front of you. A PDF
version of the manual is available on our website and this will allow you to zoom in on the
diagrams if needed.
Be very careful to not over tighten the nuts and bolts on the plastic parts, otherwise they
may crack. Everything should easily fit together, and so if it isn’t, take a step back and
re-read the instructions.
Assembly of this kit involves the use of electricity and therefore you should take appro-
priate precautions to ensure you are assembling the kit in a safe manner. When following
wiring diagrams, double check that everything is connected correctly. Before carrying out
any work on the electrics make sure that the machine is switched off.
The polarity is indicated by the color of the wire, not by the color of the connectors at
each end. A positive wire is red or brown, negative is black, and earth is green and yel-
low.
The controller is sensitive to electrical interference. Therefore we are now providing an
interference kit with machine to reduce this. In this kit ferrite beads are provided. Clip
the Motor-Ferrite's on the motor wires as close as possible to the CNC-xPro. Clip the PSU-
Output-Ferrite's on the PSU-Output-Power-Cable as close as possible to the 24V-360W-
Power-Supply. And the Router-Ferrite, as close as to your router as possible.