ooznest C-Beam Machine, Руководство по сборке

Страница: 13 / 40

C-Beam Machine Power Supply Assembly 11
A. Bring the front of the 24V-360W-Power-Supply and PSU Cover close together.
B. Following the wiring diagram, first connect both wires of the right and center XT60-
Male connectors to the 24V-360W-Power-Supply. As seen on the ring terminal attach-
ment view, the terminal screws on the 24V-360W-Power-Supply should first go
through the terminal plate, then through the ring terminal on the wires, and then into
the threaded hole on the 24V-360W-Power-Supply.
C.
If you did not attach the left-most XT60-Male connector to the PSU-Cover, then only
connect the LED-Volt-Meter to the last empty output terminals. If you intend to use a
third XT60-Male connector, then it must also be connected with the LED-Volt-Meter to
the same terminal points on the 24V-360W-Power-Supply. This simply involves screw-
ing through two ring terminals (instead of one) and ensuring they are of the same
polarity. The top ring terminal will have to be folded up in order to clear the plastic
sleeve on the lower one.
D. Finally, connect the three IEC-Inlet wires to the 24V-360W-Power-Supply. The IEC-
Inlet-Earth-Wire is very inflexible compared to the previous ones, so this wire may
take some force to get into position.