Onward Broil King Baron 440, Руководство владельца и инструкция по сборке

Страница: 7 / 20

TROUBLESHOOTING
7
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
SMELL OF GAS
SHUT OFF LP CYLINDER VALVE AT ONCE.
DO NOT USE THE APPLIANCE UNTIL LEAK IS SEALED.
Leak detected at cylinder,
regulator or other connection. 1. Regulator fitting loose.
2. Gas leak in hose/regulator or control valves.
1.
Tighten fitting and “Leak Test.” (page 3)
2. See authorized service center.
Flickering Burner Flame or
Low Temperatures on HIGH
Setting 1. Excess flow safety device has been activated
in connection between cylinder and barbecue.
1. Turn LP cylinder valve off then turn all burners to
OFF position. Disconnect the regulator from the
cylinder. Wait two minutes. Re-attach regulator to
the cylinder. Open the cylinder valve slowly. Wait
one minute. Light grill as per “Lighting” (page 4)
Burner Not Lighting 1. Out of LP Gas.
2. Ignitor issue.
3. Excess flow safety device has been activated.
4. Regulator is not fully connected to the cylinder
valve.
5. A leak in the system causing the excess flow
device to activate.
6. Orifice(s) blocked.
7. Hose is twisted.
1. Refill LP Gas Cylinder.
2. Try manually lighting burner with a match. See
“Lighting” (page 4). If burner lights successfully, it is
an ignitor issue. See “Ignitor not Working” below
3.
Follow “Flickering Flame or Low Temperatures on
HIGH setting” solution above.
4. Tighten the regulator hand wheel.
5. Leak test connections to determine loose fitting.
Tighten fitting. Leak test system.
6. Remove burner, clean orifices with a pin or fine
wire. Do not drill orifices.
7. Straighten hose.
Ignitor Not Working 1. Ignitor battery is dead
2. Ignitor wire(s) not connected
3. Electrode misaligned on burner
4. Ignitor malfunction
1. Replace battery
2. Ensure main burner and side burner electrode wires
are all connected
3. Realign electrode and clear any surrounding debris
from area
4.
Use “Match Lighting” procedure. (Page 4)
Decreasing Heat, “Popping
Sound”
1. Out of LP Gas.
2. Venturi blocked.
1. Refill LP Gas Cylinder.
2. Remove burner, clean venturi.
Regulator Humming Noise 1. Cylinder valve opened too quickly. 1. Open cylinder valve slowly.
Cooking Grid Rusting 1. Porcelain enamel has been chipped
1. See “Maintenance” (page 6) for help