39
SECTION 11
ACCESSORY INFORMATION
Figure 11-3 Re-inflating tires
DO NOT OVER INFLATE! Too much track tension can
damage bearings and axle housings.
11.3.2 Operating Precautions
A Centaur equipped with tracks cannot be used in water.
Tracked Centaur models have a reduced capacity on land.
Refer to Section 1.4.1 of this manual for additional informa-
tion on operating capacities.
CAUTION
should be observed when operating in win-
ter conditions and a drop in temperature occurs. Snow
and slush accumulation in the track could freeze, result-
ing in damage to the track system. Slush, snow and ice
accumulation should be cleared from the axles and track
periodically to prevent build-up.
CAUTION
should be observed when using any track
system on a Centaur. Make sure the guides and backing
plates are properly secured in each track. Failure to
secure them can result in lower body damage.
EXTREME CAUTION
must be observed when using
the track systems on icy surfaces. Steering and braking
effectiveness will be reduced. Reduce speed.
EXTREME CAUTION
must be observed when cross-
ing ice-covered water. The vehicle will sink if it breaks
through the ice surface and fills with water. Make sure
drain plugs are securely in place and do not overload
the vehicle. Ice must be thick enough to support the
fully loaded vehicle.
11.4 WINCH KIT (Part No. 849-114)
The 3500 lbs. winch mounts permanently to the front of the
Centaur and can be used for self-recovery and to raise and
lower the snowplow blade (Part No. 657-100). The winch
has a free-wheeling feature that allows the 40 ft. steel cable to
be pulled off the winch drum without using the winch’s 12
volt electric motor.
The electrical components and the wiring design of the winch
kit prevent the use of the winch motor unless the ignition key
is turned to the ‘on’ position. This is a safety feature that pre-
vents the unauthorized use of the winch when the vehicle is
parked.
After the installation of the winch kit is completed, test the
electrical connections by moving the toggle switch control
from side to side with the ignition switch removed. If the winch
DOES NOT operate, the connections are correct. If the winch
starts during this test, have the installer correct the wiring
connections immediately.
11.4.1 Rules For Safe Operation
1. The winch is rated at 3,500 pounds (single-line) capac-
ity. DO NOT OVERLOAD. DO NOT ATTEMPT PRO-
LONGED PULLS AT HEAVY LOADS. DO NOT
MAINTAIN POWER TO THE WINCH IF THE MO-
TOR STALLS. Overloads can damage the winch and/or
the wire rope and create unsafe operating conditions. For
heavy loads, we recommend the use of the optional pul-
ley block and hook assembly (Superwinch Part No.1503)
to double line the wire rope. (Figure 11-4) This reduces
the load on the winch and the strain on the wire rope by
approximately 50%.
Figure 11-4 Double Line
2. Periodically check the winch installation to assure that
all bolts are tight.
3. DO NOT “move” your vehicle to assist the winch in pull-
Содержание Centaur V2001DT
Страница 5: ...NOTES III...
Страница 6: ...NOTES IV...
