7
SECTION 3
OPERATING INSTRUCTIONS
3.1 STEERING
The steering wheel is used to turn the vehicle whenever the
engine is running. When moving forward, steering is similar
to an automobile. When moving in reverse, steering is oppo-
site to an automobile, similar to backing up a trailer.
When moving in reverse, steering operation is opposite
to automobiles.
The steering system works whenever the engine is running,
even when the gear selector is in neutral. The CENTAUR is a
skid steer vehicle. During a turn, the rear of the vehicle swings
outward as the vehicle pivots on the tires on the inside of the
turn. To make a right hand turn, the rear of the vehicle skids
out to the left. To make a left hand turn, the rear of the vehi-
cle skids out to the right.
When turning, the back of the vehicle swings to the op-
posite direction of the turn. Always take care to avoid
hitting persons or objects with the rear of the vehicle!
Serious injury or death can result!
The steering system is powered by a hydrostatic transmission
and works best when engine r.p.m. is higher than at idle. Avoid
turning the steering wheel when engine is idling.
Do NOT use steering unless vehicle is moving. Do NOT
use steering to assist in entering the vehicle. Damage to
the steering system could result.
Centaur vehicles built after August 2001 have a steering lock-
out system. The armrest on the driver’s side is mechanically
linked to the steering control. The steering wheel is locked in
the center position when the armrest is in the raised position.
When the armrest is in the lowered position, the steering is
unlocked and ready for use.
Ensure armrest is lowered and steering wheel moves
freely before driving the Centaur. If the steering lockout
feature malfunctions, steering will be impaired which
could cause an accident resulting in serious injury or
death.
3.2 BRAKES
The Centaur has a foot operated brake pedal. To stop the
vehicle, press firmly on the brake pedal.
3.3 PARKING/EMERGENCY BRAKE
The Centaur is equipped with a parking/emergency brake.
The lever is located midpoint under the dash and is activated
by pulling towards the driver. Release the brake by
pushing
the button on the end of the lever
and
pushing the lever as far
forward as possible.
3.4 THROTTLE CONTROL
Vehicle speed is controlled by the accelerator pedal. To in-
crease vehicle speed, press on the accelerator pedal. To de-
crease vehicle speed, remove pressure on the accelerator pedal.
3.5 STARTING PROCEDURE
Never start or run the engine in a closed building or
confined area. Engine exhaust gases contain poisonous
carbon monoxide. Carbon monoxide is odourless, col-
ourless and can cause serious personal injury or death.
All Centaur models are equipped with key operated, electric
start systems.
Centaur vehicles built after December 2001 have a neutral
safety switch that prevents the vehicle from being started
unless the vehicle gear selector is in neutral.
3.5.1 Gasoline Powered
1. Shift the transmission into neutral.
2. Use the choke if the engine is cold. Do not press down
on the accelerator pedal if using the choke.
3. Turn the key to the “START” position.
Содержание Centaur V2001DT
Страница 5: ...NOTES III...
Страница 6: ...NOTES IV...
