onsen ONHW26LP50, Инструкция по установке и эксплуатации

Страница: 5 / 46

Page
4
Version 1.0Aug 2018
halogenated hydrocarbons is safe for human breathing, however when passing through a gas flame, corrosive
elements are released and will shorten the operating life of the gas appliance.
Warranty is void when failure is due to operation of the appliance in corrosive conditions.
Warning!

Ensure that the gas supply is as stated in product data label, i.e. natural gas or LP gas. Power connection and
product installation must be in accordance with manufacturer’s instruction & local regulations.

Installation must only be carried out by authorised or qualified personnel.

The hot water heater is an outdoor unit, and MUST NOT be installed indoors.

The unit must be installed in a location where it is easy accessible for maintenance and repair.

Power plug and socket installation area should be considered waterproof or free from rain splash.

There must be no electrical wiring and electrical appliances on top of the water heater. Distance between
the water heater and electrical appliances should be more than 500mm horizontally.

Distance between water heater and the flammables should be no less than 150mm. The explosive and
volatile flammables, such as gasoline, diesel, alcohol etc must be kept far away from the water heater.

The water heater should not be installed in a location where it can be adversely impacted by wind.

If the installation location is made of flammable material, metallic heat insulation should be applied. The
distance between metallic insulation and wall should be more than 10mm and size of the insulation should
be 100mm larger than the gas water heater.

Power supply for the water heater is 240Vac, 50Hz. The power point must be reliably earthed.

Power socket should be at located to the side of the water heater, and NEVER to be under the unit.

The appliance is controlled by intelligent programmed electronic chips. Electromagnetic interference should
be kept at a safe distance from the product.

Make sure the hot and cold water connections are NOT reversed; the water heater will not operate with
reversed water connections.
The manufacture shall not be liable for any direct or indirect damage caused by faulty installation. The installer
must ensure that the product installation and connections comply will all regulations in your Country.