ONNLINE ESSENSSE, Инструкция по эксплуатации

Страница: 10 / 66

10
6. INSTALLATION
DO NOT MISS!
•
•
connect the pipes in an counterflow connection arrange-
ment, the connection of the hot heating water and the re-
turn heating water is shown in the picture (picture below).
•
We recommend that you attach shut-off fittings on to the
inlet and outlet of the heater to make it possible to shut-off
the water
3. Hanging the curtain in the installation
position
Measure out the installation holes, measure out the dimen-
sions and prepare the curtain mounts - see the Dimensions
table on page 4.
The curtain must be installed in such a way that the bottom
edge of the curtain is as close as possible to the edge of the
door. Adhere to the minimum clearance distances during in-
stallation.
The curtain can normally be installed in two ways:
1. use the installation brackets and mount it on the wall.
2. hang it on threaded rods.
Normally the curtain is hung on the installation brackets abo-
ve the door if the installation location permits. When using
the brackets you have the following options:
a - it can be used in the case, where there is at least 15 cm
above the curtain and the user does not mind that the brac-
kets are visible.
b - it gives the option for installation in the case of a small
clearance above the curtain (however, at least 5 cm). In that
case the brackets are not visible.
If there is a ventilation window above the door or another
material preventing the installation of a bracket, it is possible
to use threaded rods and to suspend the curtain from the ce-
iling connecting directly into dowels (see further in the text).
Installation using the mounting brackets
YOU WILL NEED
4x dowels (not included)
4x bolts (not included)
Screw off the brackets and according to the dimension dia-
gram (see „Dimensions“) measure out the holes on the wall
(adhere to the installation rules). Remember that it is necessa-
ry to choose, whether you will install the curtain according to
A or B and based on this set the height of the holes! Screw the
bolts that were used for attachment to the bracket back into
the holes in the curtain (only partially into the curtain) and
hang the curtain on these bolts. Check the that the curtain
is properly secured so that the curtain does not fall out
accidentally.
Installation using threaded rods
YOU WILL NEED
4x anchor 6mm (not included)
4x threaded rod M6 (not included)
8x nut M6 (not included)
Wrench M10 (not included)
A
B